How high does the wall have to come out?
Wall material is removed to a height above the waterline, according to University of Missouri Extension flood guidance. Drywall wicks water upward, so the wet area is above the visible line. A crew cuts higher than the stain, marks it level and checks the cavity behind it.
A stain line is only where the water stood. Above it, the drywall has pulled water up by capillary action, and that part may be damp and ready to grow mold even if it looks fine. Cutting above the waterline removes the wicked section and gives a straight edge for a repair.
Insulation behind the wall gets the same treatment. Fiberglass batts that were wet at the bottom hold water against studs and plates, and they dry slowly. They are usually removed along with the board. The crew checks the cavity with a meter after the cut to make sure the damp has not climbed higher inside the wall than the board suggested.
Why can't wet carpet always be saved?
Carpet can sometimes be dried after a short exposure to clean water, but the pad underneath almost never is. Contaminated water, long exposure or backing that has started to separate means both have to go. The crew decides using readings and the source of the water.
Carpet and pad are layered, with the pad holding far more water than the surface fibers. Drying the top does not dry the pad, and the pad is the part that grows mold. A pad is also inexpensive to replace relative to the risk of leaving it in place. That is the reasoning behind removing it nearly every time.
If the water was flood water or sewage, carpet is generally removed, because it is porous and cannot be cleaned through. The owner may want to keep a small sample for the insurer. Photograph the carpet before it is cut, and tell the crew if the carpet is something you want evaluated for salvage.
Can hardwood and laminate floors be saved?
Sometimes. Hardwood can often be dried with specialized equipment if the water was clean and the response was prompt, though it may cup or crown. Laminate and engineered floors swell at the seams and are usually removed. The crew checks the subfloor first and decides board by board.
Hardwood is solid and can release moisture over time, which is why it sometimes recovers. Even then, the boards may cup, crown or gap as they dry, and the floor may need sanding afterward. A crew does not promise that a floor will come back, and the owner should expect to wait and see how it settles.
Laminate and engineered boards are built from layers of fiberboard that swell when wet and rarely return to shape. Vinyl plank and sheet floors can trap water underneath. In every case, the crew lifts a section to look at the subfloor, because the subfloor is what has to be dry before new flooring goes in.
What should you do before the crew arrives?
Photograph the water and the damage, stop the source if you can do it safely, lift small items and furniture legs off wet floors, and call. Do not pull up carpet or cut walls yourself until the crew has seen the room, and keep everyone out of water near electrical equipment.
Photographs and notes help the claim and help the crew plan. Include wide shots of each room, close shots of the waterline and any affected belongings. Move small valuables, papers and electronics to a dry place if you can do so safely, and leave heavy furniture where it is unless it can be lifted without stepping into water.
Resist the urge to start tearing out materials before the crew has looked. The shape of the cut, the height of the stain and the condition of what is behind it tell the crew what happened and how far to go. Wash hands with soap and warm water after contact, and seek medical attention if anyone feels ill during cleanup.